Lance 2
Southland RV
Adventurer
Capri 2
Cirrus 2
Camper Mod Contest Entries

Replacement Table With Wall Supports

Welcome to the fifth entry in August’s Mini Mod-Ster Contest.  One engaging Mini Mod will be published in every Email Alert in August.  At the end of the month we’ll hold a reader vote to determine August’s winner.  For information about the Mod-Ster Contest, including how to enter, click here.

Stan Burbank, Concord, New Hampshire
Replacement Table With Wall Supports
2012 Ford F250
2013 Travel Lite 800 SBX

The stock table stuck out too far into the passage area. The two-inch diameter leg was in the way and the whole thing was hard to store out of the way.

Replacement Table With Wall Supports

Using 3/4-inch plywood for the table and a wall bracket, we supported the replacement table with a 3/4-inch steel pipe located close to the side wall of the seating area. This way the whole unit hides away easily.

It works great. Set up and knock down are quick and there is a lot more room to get your legs around it while sitting at the table.

It took me two-hours to complete this modification and cost me $20.  In my opinion, the skill level of this modification is easy.

Disclaimer: The modifications above are submitted by Truck Camper Magazine readers. It is your responsibility to make sure that any do-it-yourself modification project you undertake is safe, effective, and legal for your situation.

Enter Your Mods Now!

If you’d like to enter a modification you’ve done on your truck camper, click here. You can enter as many mods as you want, at any time.  Good luck mod makers!

Truck Camper Brochures
Northstar Bottom Banner
To Top