To maintain Truck Camper Magazine’s editorial integrity, truck camper and truck camper gear manufacturers are not permitted to read our reviews prior to publishing.
Jack Kay, Owner and Vice President of Operations for Torklift International, sent in the following response to our review of the Torklift International StableLoad Quick Disconnect. Here is a link to the original review; “Torklift International StableLoad Quick Disconnect Install and Review”.
“Ride Quality:
The StableLoad Quick Disconnect model is designed as a multi-piece system to give the customer the ability to perfect their ride to the finest of tune. Most users won’t find it necessary to make further adjustments once they are installed by their dealer or as a DIY project. The StableLoad is designed to allow for suspension tuning after installation for those that feel it necessary to find their individually preferred balance between overall handling improvement and ride quality.
Installation and Adjustment:
This is accomplished by using three separate wedges per StableLoad. It allows the customer to either increase lift and stiffen the suspension to improve handling and eliminate bucking, sway and body roll. It allows the customer to also remove wedges depending on the vehicle’s pre-existing overload clearances thereby reducing the lift allowing for a softer ride. Each front and rear StableLoad can have wedges added or removed and can have anywhere from one to three wedges to accomplish the individual’s desired handling and ride quality balance.
If you want to watch a video of it getting installed by the guys on Truck U television, visit this link: http://www.torklift.com/products/stableload.php
Here are some reviews on the StableLoads where your readers can learn about other customers who have tried them in adverse conditions: http://www.torklift.com/p.php?w_page=testimonials#suspension
Engaging and Disengaging:
The StableLoad: Quick Disconnect engages and disengages in seconds by simply removing a pin and clip.
Once the StableLoad is properly installed and adjusted it should not be necessary to disengage it when the truck camper is on the truck. If disengaging the StableLoad is desired while the camper is on the truck simply take a few minutes to run the camper jacks down and lift the camper’s weight off the truck suspension. It is not necessary to disconnect the tie downs for this process and it is also not necessary to lift the truck or the truck suspension up beyond its stock ride height. Simply pull the pins and disconnect.
Take a look at what customers are frequently asking us in our Q&A section: http://www.torklift.com/products/stableload_faq.php
Warranty Information and Tech Support:
The StableLoad has a unique warranty. Not only is it backed by our Legendary Lifetime Warranty, we will also warranty the vehicle’s factory suspension leaf springs. Torklift International is available at your convenience, the customer always comes first. We can be called Monday through Friday 7:30 a.m. to 5 p.m. PST at 1-800-246-8132 or 24 hours a day, seven days a week by e-mailing us at [email protected]. Whether it’s a holiday or not, we are here to help.
Customer Satisfaction Guarantee:
We are so confident our StableLoad will meet and exceed your expectations as they have for thousands of other StableLoad users, we continue to offer a 100 percent customer satisfaction guarantee. Contact us for details.”
Jack Kay
Owner/VP of Operations
Torklift International
